Rogers Wireless APN Internet Settings for iPhone and Android

Access Point Name (APN) is required by any device that wishes to connect to the internet via a 4G / LTE or 3G network. Once you have Rogers Wireless SIM card installed on your phone, input the appropriate APN settings and ensure that you have an active data plan to connect to the internet.

Rogers Wireless APN Settings for iPhone

Go to Settings > Cellular Data > Cellular Data Network on your iPhone with Rogers Wireless SIM then input the settings below:

APN: ltemobile.apn
Username: (Leave blank)
Password: (Leave blank)

To reset these settings and set them a fresh, visit Settings > Cellular Data > Cellular Data Network > Reset Settings then key in these settings. You can also access iPhone SIM applications.

Rogers Wireless APN Internet Settings for Android

Locate Access Point Name under settings then input the settings below. You will generally find this under Settings > Mobile Data > Access Point Name > Add. Proceed to input the APN settings below, save then use the newly added APN settings.

Name: Rogers LTE
APN: ltemobile.apn
Username: (Not set – Leave it blank)
Password: (Not set – Leave it blank)
Proxy: (leave it blank – not set )
Port: (Leave it blank – not set)
Server: (leave it blank )
MMSC: http://mms.gprs.rogers.com
MMS Proxy: 10.128.1.69
MMS Port: 80
MCC: 302
MNC: 720
Authentication type: (none)
APN type: (default,supl, mms)
APN protocol: (IPv4)
Bearer: (Unspecified)
Mobile virtual network operator: (none )

If you are not connected to the internet yet you have an active data plan, restart your device. For cases where you seem not to have any network bars, change your preferred network to GSM/HSDPA/LTE.

Other Canadian telecommunications service providers